启动渣浆泵的条件如下：
(1)启动前按泵的常规检查要求检查渣浆泵。
(2)确认渣浆泵管路已通、浓缩仓已选择好、进水门已开、选择的浓缩机已运行、浓缩机排渣门和冲洗门已关，排渣泵投连锁。
(3)检查渣池内无杂物，水位大于1.2m。
(4)检查渣浆泵对应的扰动器已启动，正常。
(5)将渣浆泵变频器调至小于10%。
(6)在DCS上启动渣浆泵，等出口阀全开后慢慢调整变频器的频率，让其满足回用水池的水量。
(7)渣浆泵启动正常后注意渣浆泵出水、回用水泵出水的配合和捞渣机水温。
The conditions for starting the slurry pump are as follows:
(1) Before startup, check the slurry pump according to the routine inspection requirements of the pump.
(2) Confirm that the slurry pump pipeline has been connected, the concentration bin has been selected, the water inlet valve has been opened, the selected thickener has been operated, the slag discharge valve and flushing valve of the thickener have been closed, and the slag discharge pump has been interlocked.
(3) Check that there are no sundries in the slag pool and the water level is greater than 1.2m.
(4) Check that the perturber corresponding to the slurry pump has been started and is normal.
(5) Adjust the frequency converter of the slurry pump to less than 10%.
(6) Start the slurry pump on the DCS, and slowly adjust the frequency of the frequency converter after the outlet valve is fully opened to meet the water volume of the reuse water tank.
(7) After the slurry pump is started normally, pay attention to the coordination of the slurry pump outlet and the reuse pump outlet and the water temperature of the slag dredger.
